Part # 7111857
Ring Tool 27 x 36

It's not the best built tool for sure, though I can imagine it's similar to what came in the original tool kit. The big issue for me was that the weld beads were so big that the tool could barely get a mm or two of grab on the swingarm nuts for my 1974 R75/6. 10min with the dremel helped, but it's annoying to have to do on a $45 tool The other issue is that the tool is short, and I've yet to figure out a good way to get a breaker bar on it. For my bike, which probably hasn't had the swingarm off in twenty years, I just can't get enough leverage to budge the nut. I wish Boxer2Valve sold the turned down sockets like William uses in the videos, but I didn't see them listed and went with this instead. That also means I won't be able to use a torque wrench during reassembly. But I imagine if I wasn't dealing with decades of neglect, once the welds had been ground down, it would have done the job.

Great deal on a hard to find tool.