Description Reviews Video Bike Fitment

Description

Shifter Linkage

This linkage a high quality reproduction, and unlike the replacement part from BMW, this part includes the ball studs, nuts, washers, seals and safety clips. It is an ideal retrofit and replacement for the original wire linkage of early 5 speeds from /7 through 1984 and a great replacement for corroded or worn out linkages.

Comparable to BMW part number 23 41 7 714 804

Note: When replacing the original wire type linkage with this part, it will be necessary to enlarge the holes in the shifter levers to 6mm.

23 41 2 301 391
23412301391

Customers Who Bought This Product Also Bought

**Copper Seal Rings**

★★★★★ ★★★★★

Assortment of Sizes Available Starting At: $0.35

**Aluminum Seal Rings** Assortment of Sizes Available Starting At: $0.35

**Drive Shaft Bolt**

★★★★★ ★★★★★

$3.15

**Copper Crush Seal Rings**

★★★★★ ★★★★★

Assortment of Sizes Available Starting At: $0.60

**Flywheel Bolt M11x1.5**

★★★★★ ★★★★★

$4.95

**Speedometer Cable Boot, Improved Design**

★★★★★ ★★★★★

$12.95

**Rear Crankshaft Seal**

★★★★★ ★★★★★

$29.95

Reviews
Write a review

★★★★★ ★★★★★

5/5 Stars out of 3 Reviews

Write a Review

5 ★

4 ★

3 ★

2 ★

1 ★

Shifter Linkage

★ ★ ★ ★ ★

Frazer Torode | November 15th, 2021

I purchased this due to the fact that I could not shift from one gear to the next. I thought the original bent wire unit had suffered as a result of the bike being knocked over by a falling Maple tree limb. I was wrong, upon installing this new (far more flexible link) there was no change. I need to dig deeper.

Verified Buyer

Nice backup part

★ ★ ★ ★ ★

Jim Harrison | April 3rd, 2021

I'm getting backup parts. Original shifter linkage is serviceable. Well made and should last for years in the plastic bag it came in. This will sit in the tool kit until needed.

Verified Buyer

Shifter linkage

★ ★ ★ ★ ★

Anthony | September 3rd, 2018

Finally got around to using this to replace my stock shift linkage on my ‘78 R100/7 BMW, easy swap out, it’s adjustable and an improvement for sure. Required 6mm bit to enlarge the mount holes, but that’s easy, too. Suggest using blue loctite to keep the 10mm nuts where they should be.