My Cart: 0 item(s)
Description
Reviews
Bike Fitment
Description
Spark Tester
Ignition System Tester - Suitable for checking
the ignition voltage and its performance. The performance can be
measured by adjusting the installed screw.
Instructions:
Important:
- Measuring range: 0-40,000 volts
Instructions:
- Disconnect the plug and plug it into the ignition tester
- Attach the crocodile clamp to the ground
- Set the screw to approx. 10mm (an intact ignition system should skip the spark gap of approx. 15mm)
- Make sure that the ignition tester can not get near the ground
- The engine can be started
Important:
- In the case of multi-cylinder engines, the remaining plug plugs must be grounded (otherwise damage the ignition parts)
- If spark plugs should be removed, please note that an explosive mixture could escape through the spark plug openings
- Adjustment of the spark gap via the screw may only be carried out with the ignition switched off
- When the ignition is switched on, neither the ignition system nor the spark detector can be touched
